Set Up the GamePad (DRC) for the CAT-R

In the following three sets of instructions, you will set up the Display Remote Control (DRC), pair the DRC, and then update the DRC firmware.

Set Up the DRC

  1. Connect the AC adaptor to the DRC, and then plug it in to an electrical outlet.
    DRC power connector
  2. Connect the coaxial cable from the DRC to the DRC1 coax port on the CAT-R.
  3. On the top of the CAT-R, set the switch labeled DRC to Wired.
  4. Set the switch on the side of DRC coaxial connection to the position closer to the DRC body. The position closest to the DRC body is labeled Wired, and the other position is labeled Wireless.
    DRC switch position
  5. Connect the Classic Controller Pro to the Classic CON port on the CAT-R.

Pair the DRC

  1. Turn the CAT-R on. After a short wait, the System Config Tool is displayed on the television screen.
  2. To sync the Wii U Remote to the CAT-R, press the SYNC Button on the CAT-R and on the controller.
  3. Using the Wii U Remote, select the DRC Setting… option, and then press the A Button.
  4. Select the Pair DRC… option, and then press the A Button.
    Pairing DRC display
  5. To turn the DRC on, press the POWER Button on the unit.
  6. Use the stylus to press the SYNC Button on the back of the DRC.
    SYNC Button on the DRC
  7. A PIN is displayed on the television screen. Enter the PIN on the DRC. When the Main Menu is displayed again on the television, the pairing is complete.

Update the DRC Firmware

  1. Using the Wii U Remote, select the DRC Setting… option, and then press the A Button.
  2. If the Update WOWL… option:
    • IS available, select it using the Wii U Remote, and then press the A Button. The update will start. It may take a several minutes for the update to complete, and the DRC may power off at the end of the update.
    • IS NOT available, go to the next step.
  3. Select the Update DRC Firmware… option, and then press the A Button on the Classic Controller Pro. The update will start. It may take several minutes for the update to complete, and the DRC may power off at the end of the update.
  4. The DRC is now updated and may need to be paired again. If you need to pair the DRC again, repeat the Pair the DRC steps.

Update DRC Firmware for SDK 2.10.03

For SDK 2.10.03, CAT-DEV MP and DRC-DK MP / DRC-DK-TV use firmware version 23.8. The firmware configurations for DRH and DRC firmware are shown in the table below. The micro versions are now omitted in the System Config Tool.

Configuration DRH version DRC version
Factory shipping 11.0.4506 11.2.4736
SDK 2.03 11.3.4910
SDK 2.04 16.1
SDK 2.05 17.0
SDK 2.06.00 19.1
SDK 2.06.01 19.3
SDK 2.06.03 20.7 20.6
SDK 2.08.07 21.16
SDK 2.09.03 21.20
SDK 2.09.04 21.24
SDK 2.09.06 21.26
SDK 2.09.09 21.30
SDK 2.10.02 23.6
SDK 2.10.03 23.8

Revision History

2013-10-28 Add DRC version table.
2013-05-08 Automated cleanup pass.
2013-02-15 Initial version.


CONFIDENTIAL