wumad file is the master archive file that contains the RPX and RPL executable files,
data files used by the application, metadata accessed by system features, and other application information. The following steps describe how to debug a
wumadfile for your application.
caferun -e h:<hdd-bank> -d multi -k <elf-file>where
<hdd-bank>is the Hard Disk Drive (HDD) bank that you selected in step 1 and
<elf-file>is the debugger file for your application (such as
cafediscruncan also be used to launch the application.
cafe.batwindow, enter the following command:
devkitmsg "pm_restart 0x000500101000800A" // Restarts the system and boots into Sys Config ToolAfter the System Config Tool has restarted, proceed to step 5.
devkitmsg "cos_flags 0x768" // Turns off debugging devkitmsg "pm_restart 0x000500101000800A" // Restarts the system and boots into Sys Config ToolThe
cos_flagscommand disables the debugging mode that was enabled by
-d multiin step 2, and the
pm_restartcommand applies the mode change.
wumadmanually through the Title Launcher: in the System Config Tool, navigate to Title Launcher and launch the title ID under ODD2. MULTI should launch and open the
<elf-file>specified in step 2.
restartto start debugging.
cafe.batwindow, enter the following command to stop the system:
2014/02/03 Initial version.